Tools required:
1. Standard screwdrivers
2. Application Fluid - Any
pump spray bottle full of
water and mixed with a
few drops of dish soap
works too.  (recommended)




Cluster Removal

1. Remove warning light
panel/fascia above the
steering column.
(2 screws at top)


2. Remove tach and speedo
shroud. (4 screws)





3. Remove tach and speedo
clear lens covers.
(6 screws)



4. Remove round black
gauge bezels and set aside.
Remove the top cluster
housing screws.
(2 screws on each side of
the engine warning lights
in the center)



5. Remove the black
auxiliary switch cover on
the right of the steering
column. It uses the same
screw to hold the bottom
of the speedo cluster in
the dash.
(3 screws)


6. Remove the black
headlight switch cover on
the left of the steering
column. It uses the same
screw to hold the bottom
of the speedo cluster in
the dash.
(3 screws) 

7. Finish removing the
entire speedo and tach
cluster from the dash.
(tilt the steering wheel
to the lowest position
and unplug the electrical
connector).

8. Remove the center
gauge cluster shroud.
(6 screws)





9. Remove the gauge
cluster clear lens.
(2 screws)



10. Remove the center
gauge cluster from the
dash (6 screws). Unplug
the rear electrical
connector.





  

General notes:
1. Pointers are NOT removed.
2. Pointers will return to
   normal positions when
   engine is started.
3. Remove "NEGATIVE" battery
   terminal.





























     

 Speedo / Tach Overlays

1. Placing the cluster
on a flat surface. Using a
Philips head screwdriver
remove the 3 screws on the
back of the speedometer so
that the speedometer can be
removed from the housing.



2. Remove the 3 screw
on the back of the tachometer
so that it can be removed
from the housing.








3. Remove the two smaller
screws on each side of the
needle hub prior to
installing the overlays.

4. Lightly mist each of
the faces with the application
fluid prior to installation of
the overlays


5. To apply, peel off the
backing of the overlay and
discard. Point the needle
toward the top of the
instrument and slide the
overlay down and over the
needle. The overlay will
then slip over the needle
stop. Adjust the alignment
of the numbers and press
down, adhering it to the
face. Then remove the top
transfer tape and backing.
Use your fingers to squeegee
out any air or water pockets.




Small Gauge Overlays

1. These can be installed
with out removing them from
the housing. 

2. Remove the two smaller
screws on each side of the
needle hub prior to
installing the overlays.

3. Lightly mist each of
the faces with the application
fluid prior to installation of
the overlays

4. To apply, peel off the
backing of the overlay and
discard. Point the needle
toward the top of the
instrument and slide the
overlay down and over the
needle. The overlay will
then slip over the needle
stop. Adjust the alignment
of the numbers and press
down, adhering it to the face.
Then remove the top transfer
tape and backing. Use your
fingers to squeegee out any
air or water pockets.

5.. Reverse the steps for
reassembly. 

Tips:


1. Clean the instruments
clear lenses with plastic
polish to restore their
clarity.

2. Replace instruments
back lighting with red or
blue accent bulbs. These are
easily found at most any
auto stores.