General items needed for installation

1. Cleaning solution. Any of the following will
work great:
-   Rubbing Alcohol  (found at most any grocery Store)
-   Bug and Tar Remover (found at most any auto store)
-   Any type of sticker remover



2. Film or application fluid. Any of the following
-  Rapid Tac application fluid  (sign supply store)
-  Any spray bottle full of water and mixed with a few
   drops of dish soap works too (recommended)




3. Squeegee. In some cases a squeegee is needed
for a bubble free install. A squeegee will be needed
for this install.



 

Application Instructions

1. Use one of the cleaning solutions list on
the left to clean the surface of the hood, removing
any elements that might prevent the vinyl from
adhering properly. This will also remove any bug or
tar chunks that might get trapped under the decal.

2. With a tape measure, mark the center of
your hood from each hood hinge. Then run your tape
measure down the hood aligning it with the center
of the grill and mark the center. 

3. Place the body of the Spider on the
center line and tape the edges of the decal in
place so it can not move. Align and tape down the
Spider legs evenly.


  

4. Lift up only half of each section from the
hood at one time. Cut half of the backing off with
scissors.  Spray the surface with application fluid
and apply that half to the vehicle. Lift up the
remaining side and do the same. Use a squeegee to
remove any air or fluid under the lettering and peel
off the top transfer tape. If applying chrome decals
to not scratch the mirror finish during the squeegee
process. Try using the palm of your hand or a roller
squeegee. Repeat on all 3 pieces.


  

5. Dry the hood off.Apply some wax to the
surface and surrounding areas to help seal in the decal.