Jeep TJ Flame Set Application Instructions Caution: Be careful of the chrome or “metal” based vinyl material to not bend the decals too far and crease them. On Chrome use a “light” amount of application fluid and do not slide the decal around. The glue can wash off and render the decal tack-less.

General items needed for installation 1. Cleaning solution. Any of the following will work great: - Rubbing Alcohol (found at most any grocery Store) - Bug and Tar Remover (found at most any auto store) - Any type of sticker remover 2. Film or application fluid. Any of the following solutions will work: - Rapid Tac application fluid (sign supply store) - Any spray bottle full of water and mixed with a few drops of dish soap works too (recommended) 3. Squeegee. In some cases a squeegee is needed for a bubble free install. A squeegee will be needed for this install. Note: After installation you might have some remaining bubbles. This is normal. Wait about a week and most of the bubbles will disappear and the trapped water will evaporate. The warmer the weather the quicker. The remaining bubbles are probably air. Take a small pin or razor and poke little holes to let the air out with your finger. The first couple wax coats be careful around the flame tips until you build up some wax on the edges. After wax is built up around the decal you will not have to be as careful.

Application Instructions 1. Use one of the cleaning solutions list on the left to clean the surface of the hood, removing any elements that might prevent the vinyl from adhering properly. This will also remove any bug or tar chunks that might get trapped under the decal. 2. With a tape measure, mark the center of your hood from each hood hinge. Then run your tape measure down the hood aligning it with the center of the grill and mark the center. Apply the decal in the order you see numbered above. 3. Place the #1 Decal on the center hood and tape the edges of only one side in place so it can not move. 4. Lift up the free half of the decal from the hood and cut half of the backing off with scissors. Mist the surface with application fluid and apply that half to the hood. Lift up the remaining side and do the same. Use a squeegee to remove any air or fluid under the lettering and peel off the top transfer tape. If applying chrome decals, spray only a “very light” mist of fluid. Don’t be to anxious to pull the top transfer tape off. If it appears not to stick then let it sit until some of the water evaporates and it will become tacky again. Also, be sure to not scratch the mirror finish during the squeegee process. Try using the palm of your hand or a roller squeegee. Repeat on #2 decal. 5. On decal #3 cut out the area where the hood latch is supposed to go with scissors. Also it will be easier if you cut the 2 small flames next to the latch off from the main decal and apply them separately. Apply the top half of the decal first by taping the lower horizontal half down to hold it in place. Before applying the decal be sure to take the #4 decal and lay it in place to see if it fits how you want it. Apply #4 decal next and repeat on #6 and #7 decals. 5. On decals #7 and #8 use the same method by taping half the decal down to hold it in place. Align them by using the seam in the fender. 6. Dry the hood off. Lightly warm them with a hair dryer or heat gun to help adhere them if applying them in cold weather. Apply some wax to the surface and surrounding areas to help seal in the decal.